Aluminum NRS

Fat Cat Cataraft Rowing Frame

Fat Cat Frame Parts List: (2) Yokes (4) Side Rails (2) Cross Bar (1) Seat Bar (2) Foot Bar (1) Pair of Oar Mounts (1) Pair of Cooler Mounts (2) 9ft straps (4) Strap Slides (1) Frame Wrench (20) U-bolts (40) Washers and Locking Nuts (2) High-Back Drain Hole Seat with bolts and washers Note: Side Rails, Cooler Mounts and Seat are packaged separately.

Instructions:

1. Lay out the frame parts as shown in the image above. Place the yokes upside down with the narrow end up.
    
2. Install U-bolts on the inner yoke LoPros. Add the washers and the nuts, leaving them loose. Slide the two inner side rails in through the U-bolts, then tighten the nuts.
    
3. Turn the yoke right side up so that the inner rails are supporting the frame. Follow step 2 with the outer rails.
    
4. Set the seat, foot, and cross bars in place and add the U-bolts, nuts and washers leaving them loose. Be sure that the side marked \"Front\" on the seat bar faces forward. Adjust the crossbars so that they fit against the cooler or dry box snugly. If any of the bars need to be repositioned, it may be necessary to remove the U-bolts to make adjustments.
    
5. Add seat, cooler mounts, and oar mounts.
    
6. Check to be sure that all of the U-bolts are tight. Periodically check the tightness of all nuts and bolt.

Oversize Freight Applies! Oversize freight applies to this item. Read more about oversize freight.